How to Make a Squirrel Snare Using Survival Skills
Before you can construct a squirrel snare, you must determine the best location for putting it. The most convenient place to place it is on the ground, but you can also place it on large branches or logs. Your snare should be made so that the snare loop is the same size as the noose. Then, make sure that the trigger bar is deep enough to hold the sapling downward and the noose is small enough to release when the animal goes through the noose. Once the animal breaks free, it will likely get snared in the process.
Next, you need to cut a length of wire and a pencil. Loop the wire around the pencil twice and pull it out of the pencil. Once you have the length that you want, you can place the other end of the wire inside the loop. To make it easier to hook the squirrel, use a ruler and tape measure. You can also place the snare in an area where squirrels are often active.
When constructing the trap, you need to ensure that it’s strong enough to suspend a squirrel in the air. In most cases, the best option is to use a young flexible sapling or small tree. You can also use a rock for the leader line. Lastly, test the trap on a similar weight. Then, you can place the trap in an appropriate location.
Now, you need to make the snare. To do this, cut the wire and wrap it twice around the pencil. Once you have a loop, twist it. After you have done that, pull the pencil out. Remember to cut the wire long enough that it reaches the bottom of the tree. Then, place the snare on the bottom of the pencil to catch the squirrel.
To catch a squirrel, you must place multiple snares on your property. A few snares in a prime location are more effective. If the trap is set on a tree, you should place it at a distance of about two to four inches. The height of the wire will depend on the size of the rodent. In general, the smaller the snare, the better.
Wires can be used to attach the snare to a tree. You can use a piece of wire of any size as long as it is no longer than 3 inches in diameter. When you are ready to erect the trap, you need to place the bait and the wire loops at least six feet apart. Afterward, you should wait for the squirrel to come to the snare.
The snare should be 12 inches apart, but you must keep in mind that larger squirrels may require modifications. If you want to catch larger animals, you should place more snares on the same pole. When you are building the snare, make sure that the bait is enticing to the squirrel. The bait should be a delicious snack. For greater effectiveness, set two snares on each tree.
Read More: How Far to Relocate a Squirrel
A wooden pole and wire snare is a classic squirrel snare that requires no bait. The wooden pole is four to six feet in diameter and should have a fork at one end. Once you have placed the noose, you should place it in a high-traffic area. This is because squirrels tend to take shortcuts. The snare needs to be wide enough to catch the animal.
Moreover, you can make your own snare by cutting the wire and tying it to a stick. To make the squirrel snare, cut the wire and loop it twice around a pencil. Then, you should twist the pencil so that the wire is twisted tightly. This is how to make a squirrel snare. You can also use your old rod to trap the squirrel.
Jessica Watson is a PHD holder from the University of Washington. She studied behavior and interaction between squirrels and has presented her research in several wildlife conferences including TWS Annual Conference in Winnipeg.